birdflu
Velociraptor
Posts: 46
Reg: Apr 21, 2013 13:45:29 GMT
|
Post by birdflu on Apr 27, 2013 14:23:03 GMT
Hi all, I have fitted a b6 clutch cover to 1127 to change from a hydro clutch. Is there a reccomended cable to use on this adaption with the original bars fitted. The bike is a 750k with 1127 motor fitted. I was thinking gsxr400 as a guess.
|
|
|
Post by fatblokeonbandit on Apr 27, 2013 16:58:00 GMT
i have that on my harris, b6 cover on a 1127 and i used b6 lever and cable all worky loverly jubberly.........
|
|
birdflu
Velociraptor
Posts: 46
Reg: Apr 21, 2013 13:45:29 GMT
|
Post by birdflu on Apr 28, 2013 10:06:32 GMT
Nice 1, I have stainless bar to use as an adapted pushrod. The original 1127 one is too short. Has anyone got any idea of a rough length of pushrod to work from, cheers.
|
|
|
Post by fatblokeonbandit on Apr 29, 2013 18:42:54 GMT
I cant remember but heres the one I made next to the 1127 one, I think? ?? anyway get some 6mm wodden dowel and use that as its much easier to cut down a bit and use as a template than stainless rod...
|
|
|
Post by gray7/11 on Apr 29, 2013 18:52:58 GMT
Yep, I second that. Got the same set up on my 7/11. Uklee had a good write up on this but is on the old site.
|
|
|
Post by Del on May 6, 2013 11:38:30 GMT
I'm using an 11k rod,teapot 6 actuator arm,fish cover,srad6/750 cable,gsxr1000 chinese lever and srad6/750 perch When i was using the teapot(same cable,etc as above),i still used the 11k rod and had no trouble with length.
|
|