lucas1234567
Oviraptor
Posts: 17
Bikes: GSXR WN RF
Reg: Jun 9, 2013 15:38:18 GMT
|
Post by lucas1234567 on Apr 23, 2014 15:15:37 GMT
Hello, I've recently put on some led indicators on my bike which I brought resistors for that slowed down the flash but not enough.. So I brought a led flash relay , when turned on the indicator stays on... So I thought its probably the led relay so I tried another, same problem! It's gonna fail mot cause it flash's above 120 pm And I'm certain they won't allow 1 pm lol.. Any help would be appreciated! Thanks!
|
|
Deleted
Posts: 0
Reg: Mar 29, 2024 7:24:00 GMT
|
Post by Deleted on Apr 23, 2014 16:03:26 GMT
i had same problem . on mine i didnt put led,s on the front just the back ? then swapped them for the same and got earth wrong and blew relay i fixed it buy putting another pair of indictors under the seat ? or try here bugman ok oss-popcorn
|
|
|
Post by katanadave on Apr 24, 2014 7:34:19 GMT
did you leave resisters on as well?
|
|
lucas1234567
Oviraptor
Posts: 17
Bikes: GSXR WN RF
Reg: Jun 9, 2013 15:38:18 GMT
|
Post by lucas1234567 on Apr 24, 2014 9:42:49 GMT
No I've been using the relays on there own. I did try with the resistors though but obviously didn't work.. I've checked the fuses.. It wouldn't have any thing to do with the switch would it? Thanks
|
|
Deleted
Posts: 0
Reg: Mar 29, 2024 7:24:00 GMT
|
Post by Deleted on Apr 24, 2014 18:41:51 GMT
there is a relay ? you can open it carefully there is a circuit board in there if you look carefully at it the solder will be broke resolder it ok just too say this was done on a k2 thou ok,
|
|
|
Post by patrickh403 on Apr 25, 2014 7:42:08 GMT
I had the same on my GSX1100, I removed the resistors and just replaced the old relay with a LED one, about £3 from local bike shop, works fine with no extras hidden etc..
|
|
lucas1234567
Oviraptor
Posts: 17
Bikes: GSXR WN RF
Reg: Jun 9, 2013 15:38:18 GMT
|
Post by lucas1234567 on Apr 26, 2014 9:23:51 GMT
Ye that's what I've done , but won't work, did you use a 2 pin relay?
|
|
|
Post by patrickh403 on Apr 26, 2014 9:58:42 GMT
Hi, mine is a 3 pin, just swapped for the old one..
|
|
evilchicken0
Oviraptor
Posts: 14
Bikes: Bimota SB6, FZR400RR x2.6
Reg: Apr 9, 2014 16:46:22 GMT
|
Post by evilchicken0 on May 7, 2014 10:49:15 GMT
The different relays have different resistance you have balance the total to get it flashing at the right rate which can mean some messing about ... as you've found out. Have a look at the set up that works and add the resistance on two of the bulbs, then do the same with the bulb + led and and find the difference ... balance the two with the resistance of the flasher relay and / or the additional relays you already have
PITA innit
|
|