aidzuki
Oviraptor
location Durham
Posts: 14
Reg: Dec 13, 2013 17:31:40 GMT
|
Post by aidzuki on May 1, 2014 16:54:42 GMT
I have a 750 SRAD which i am having problems with the generator/regulator wiring getting very hot . I have swapped the regulator and the generator but the problem persists . It is only the three generator wires which leave the block connector and then go to the regulator. Apart from fitting another harness anybody got any ideas ,Could it be that the wires are now foooked after getting to hot?
|
|
|
Post by slim on May 1, 2014 22:37:07 GMT
Ive seen this a few times on various bikes & it usually happens if there a cheepo connector on there anywhere or the stock one isn't fitting too well, soldering the wires directly to each other usually sorts it but makes it a pain if you need to remove them again, failing that a good quality connector from wiring products soldered & heat shrunk will do the same
|
|