|
Post by bigkenx on Jun 12, 2015 17:41:49 GMT
You are on it mate , will be awesome
|
|
|
Post by stuey on Jun 12, 2015 17:46:14 GMT
this conversion is far superior to the usual rgv frame conversion which has been done a million times next up is the pipes and fitting kit . keeping it on standard bores and disc valves till i hav. it running then its going to get the carbon fibre d/v s fitted and thr 570 kit i have theres a shitload to do target gpt the bhp is 110/120 horse. and then theres the g/box. which is made of cheese. that needs upgrading or get a nova box £2100
|
|
|
Post by bigkenx on Jun 12, 2015 18:24:49 GMT
Mmmm I've got a 2 stroke in the garage but it's not politically correct , can't wait see this beast stu
|
|
|
Post by quazi on Jun 12, 2015 19:46:06 GMT
The makings of a corker!
|
|
|
Post by captain chaos on Jun 12, 2015 20:46:48 GMT
|
|
|
Post by bigkenx on Jun 13, 2015 7:36:30 GMT
I must admit captain you have some quality captions ha ha
|
|
|
Post by stuey on Jun 13, 2015 7:42:45 GMT
Lol
|
|
|
Post by busaash on Jun 14, 2015 9:59:15 GMT
Cracking start too your build stuey , you have been teasing us from the old site about this build really happy that your doing this build now , good luck and loving the quality parts so far
|
|
|
Post by stuey on Jun 14, 2015 12:07:50 GMT
its taken a while to decide to go down this route and some tough decisions like no katana anymore and that would have been a corker too but cash is not there for 2 hot bikes
|
|
|
Post by busaash on Jun 18, 2015 14:53:22 GMT
I am sure having the rg 500 as a bike will be a really outstanding bike to build
|
|
|
Post by stuey on Jun 19, 2015 17:34:07 GMT
I cut the top mounts from the rs frame today these needed to go as you need to get the motor further back in the frame
|
|
|
Post by stuey on Jun 19, 2015 17:35:08 GMT
Now it's further back
|
|
|
Post by stuey on Jun 19, 2015 17:36:33 GMT
Three cut outs to do one for the clutch casing so I can get the motor a wee bit over to the right and one each for the back carbs
|
|
|
Post by stuey on Jun 19, 2015 17:39:13 GMT
Also getting on with polishing this and removing the sand cast from the top of the arm. The anodising is well hard to remove ;(
|
|
|
Post by bigkenx on Jun 19, 2015 17:40:23 GMT
This is porn
|
|