|
Post by CHR15 on Jun 22, 2013 17:41:13 GMT
im sure it was on the old forum, but can someone remind me which stick coils fit into a bandit head.
ta
|
|
|
Post by duckndive on Jun 22, 2013 18:42:30 GMT
there all much the same so i guess busa or gixer ones would...i think i have 4 x ZX12 ones kicking around if you need some ?
|
|
|
Post by katana on Jun 22, 2013 22:50:07 GMT
These are GSXR1000 ones - mucho longer than std gixer / bandit!
|
|
goatblower
Oviraptor
Posts: 16
Bikes: gsxr937wn
Reg: Jun 15, 2013 14:48:22 GMT
|
Post by goatblower on Jun 23, 2013 9:55:33 GMT
Srad ones are shorter but has such low resistance in each coil 0.6 ohms so that only gives 1.2 ohms for each set and the standard coil is 3 ohms
Gb
|
|
|
Post by nitro on Jun 23, 2013 15:46:35 GMT
I use also GSXR1000 coils in my 1100W turbo, but with sequentiel efi for sure (no orig. CDI).
|
|
|
Post by CHR15 on Jun 24, 2013 18:50:27 GMT
might buy some 750 srad ones, if there the shortest.
ohm's dont really matter; im running an ms v3 with external bosch driver.
any idea where i can buy new connectors to fit those coils?
|
|
goatblower
Oviraptor
Posts: 16
Bikes: gsxr937wn
Reg: Jun 15, 2013 14:48:22 GMT
|
Post by goatblower on Jun 24, 2013 19:04:16 GMT
Buy a r6 coil loom it's about £20 off eBay that's what I used I am going to retry fitting my coils but run either a microsquirt or use a srad cdi
|
|
|
Post by CHR15 on Jun 24, 2013 19:15:42 GMT
|
|
goatblower
Oviraptor
Posts: 16
Bikes: gsxr937wn
Reg: Jun 15, 2013 14:48:22 GMT
|
Post by goatblower on Jun 24, 2013 21:56:52 GMT
Now that looks good
Gb
|
|
|
Post by nitro on Jun 27, 2013 16:45:27 GMT
I also alway buy complete looms and strip it (cable, connctors etc...)
|
|