suban12
Velociraptor
Posts: 49
Reg: Apr 18, 2013 16:03:40 GMT
|
Post by suban12 on Apr 21, 2013 14:07:43 GMT
Hi all.Going to be fitting rs 38 mikunis to my bandit soon.Engine spec as follows 1216 11.1 comp,ported head,gsxr 750 cams,hindle system and dyna ignition.Curious as to what you guys are running for jets or a good baseline to start from.Thanks in advance.
|
|
|
Post by mcleanracing on Apr 21, 2013 16:26:17 GMT
135 mains, needle clip on middle notch, mixture screw half turn out
|
|
dabubster
Velociraptor
Posts: 20
Reg: Apr 18, 2013 22:24:53 GMT
|
Post by dabubster on Apr 21, 2013 22:22:59 GMT
I found my pilot screws too small, turns out they were 15's not 17.5's (standard). Still a tad lean after I stuck 20's in so gonna go up to 22.5's next. Mines 1186,ported with big cams etc.
|
|
suban12
Velociraptor
Posts: 49
Reg: Apr 18, 2013 16:03:40 GMT
|
Post by suban12 on Apr 23, 2013 2:58:30 GMT
Thanks for the info guys.Will try them on the weekend and see how it goes.
|
|
dabubster
Velociraptor
Posts: 20
Reg: Apr 18, 2013 22:24:53 GMT
|
Post by dabubster on May 2, 2013 21:47:19 GMT
I meant pilot jest were too small, apart from that all standard jetting worked well.
|
|
suban12
Velociraptor
Posts: 49
Reg: Apr 18, 2013 16:03:40 GMT
|
Post by suban12 on May 3, 2013 0:09:56 GMT
Stuck with standard settings seems to run ok.Have it booked in for dyno run on Friday so we will see whats going on then.Will post up results and jetting then.
|
|