quexpress
Velociraptor
Posts: 39
Bikes: 2 X 1980 GSX1100ET, 1985 GV1200, 2000 Valkyrie
Reg: May 21, 2013 0:12:58 GMT
|
Post by quexpress on Aug 26, 2013 17:17:54 GMT
Hi! I have taken pivot width measurements of a 1983 GSX1100E swing-arm. The result is 220 mm for the swing-arm by itself or 225 mm when including the large washers and dust seals on each side. Are the pivot swing-arm widths the same for all GSX1100Es (80 to 83)? I ask this because I have a 97 GSXR1100 swing-arm that I need to bring to the machine shop in order to make the pivot width the same as the one on my 1980 GSX1100ET. I would like to do this before taking the swing-arm off my ET. Note: The center spacer, the 2 small spacers and the 2 bearings are the same for all of these bikes ... which makes me think that the swing-arm width is the same. However it would be safer to have an exact measurement of an ET swing-arm before getting my GSXR one modified. Any insight would be very appreciated! Thanks! Normand
|
|
|
Post by stockcar on Aug 26, 2013 17:27:27 GMT
yep same arm as in Kat 1100, etc. also........
|
|
quexpress
Velociraptor
Posts: 39
Bikes: 2 X 1980 GSX1100ET, 1985 GV1200, 2000 Valkyrie
Reg: May 21, 2013 0:12:58 GMT
|
Post by quexpress on Aug 26, 2013 17:42:17 GMT
Since the part numbers are different from one year to another, I was not sure.
Thanks a lot! Much appreciated! :-)
|
|