suban12
Velociraptor
Posts: 49 
|
Post by suban12 on May 4, 2013 17:26:59 GMT
Hi all.Anyone got any info on fitting busa mk 1 rods into bandit motor?Size of block spacer or machining pistons etc.Just trying to do some research.Got a spare bandit motor apart at the moment and just curious as to whats involved for fitting busa rods.Thanks in advance.
|
|
|
|
Post by nitro on May 14, 2013 12:17:16 GMT
Have gen 2 busa rod with GSX1400 pistons in my B12 turbo. The rods should be same length like busa gen 1 and are 119,5mm (B12 117mm), but have 18mm pin. The GSX 1400 pistons deeper than the B12 ones, so I needed a 1,2mm spacer with a second foot gasket for original quish.
I think you may need a 2,3mm base spacer with a second foot gasket for original squish. 2mm base spacer might be possible with sec gasket is possible for nearly zero deck (more CR). The squish is the head gasket.
|
|
suban12
Velociraptor
Posts: 49
|
Post by suban12 on May 14, 2013 14:06:38 GMT
Thanks for the info Nitro.  |
|
suban12
Velociraptor
Posts: 49
|
Post by suban12 on May 14, 2013 14:06:51 GMT
Thanks for the info Nitro. |
|
