|
Post by clivegto on Apr 4, 2014 18:36:53 GMT
All I had to do then was block of the main oil gallery where the switch came from. so chopped a spare switch in two and filled it with weld.
|
|
|
Post by clivegto on Apr 4, 2014 18:41:24 GMT
Just to be safe filled other end with J B weld.
|
|
|
Post by clivegto on Apr 4, 2014 18:45:16 GMT
Bung fitted with a slight smear of locktite on threads.
|
|
|
Post by clivegto on Apr 4, 2014 18:50:42 GMT
Case fitted, think I will blank the top bit of where the wires run with black silicone.
|
|
|
Post by clivegto on Apr 4, 2014 18:56:57 GMT
Had to move Yoshi multi meter sensor from main gallery, fits nicely here might give slightly lower oil temp but will still give me an idea of what is going on temp wise.
|
|
|
Post by clivegto on Apr 4, 2014 19:04:17 GMT
Was well happy when I found these in my shed of bits got them for me slabby fighter forgot I had them.
|
|
|
Post by clivegto on Apr 9, 2014 17:53:15 GMT
Got this GPR steering damper for the project, started to fit it tonight.
|
|
|
Post by clivegto on Apr 9, 2014 18:02:48 GMT
Top yoke is R1 as are the forks but the yoke has gsxr w top yoke cut up and welded on to make a stepped top yoke.
This pic shows that a spacer is needed for spindle.
|
|
|
Post by clivegto on Apr 9, 2014 18:07:23 GMT
Sam made this spacer for me a while ago to lift the top yoke above the frame bracing so I could get good turning circle.
|
|
|
Post by clivegto on Apr 9, 2014 18:17:07 GMT
Luckily the spacer splits in two and with a quick sniff of the file round the damper bracket it fit snugly.
|
|
|
Post by clivegto on Apr 9, 2014 18:21:52 GMT
Had to cut grub screw lugs of damper bracket as it would not sit flat on yoke.
|
|
|
Post by clivegto on Apr 9, 2014 18:26:37 GMT
Yoke spindle is going to be too long so will have to cut a bit of the top.
|
|
|
Post by clivegto on Apr 9, 2014 18:29:04 GMT
Will have to cut spindle nut down as well.
|
|
|
Post by clivegto on Apr 9, 2014 18:41:55 GMT
When I made the top yoke I had some infills welded in for strength where the risers bolt on. Will have to drill and tap into this again to bolt damper bracket as the grub screw stabilizers are gone now.
|
|
|
Post by clivegto on Apr 9, 2014 18:49:13 GMT
Looks like this sat loosely on bench.
|
|