|
|
Post by canamant on May 5, 2015 19:02:55 GMT
I know some of you have done this fitment. I've got mine all tucked up tight and as far as fit goes it's OK. However the oil lines are perilously close to the pipes so much so that the foam on the hoses started smouldering. I've removed the faoam but it's still close. What solution have you come up with ?
Thanks
Ant
|
|
|
|
Post by jaydee on May 6, 2015 14:21:29 GMT
Have a look at the link. Every type of heat shield and barrier ever needed. You could wrap the area with aluminised heat barrier and for extra shielding pull over a silica sleeve (good for 982 C) and fix it in place with some stainless snap straps. The silica sleeve is strechy so will pull over the oil cooler fitting with a bit of careful work.  www.agriemach.com/ |
|
|
|
Post by canamant on May 13, 2015 20:53:53 GMT
Thanks
|
|
|
|
Post by slim on May 13, 2015 22:42:35 GMT
Replace hoses with s/s braided a bit longer so you can route them out of the way  |
|
