sealant/bond for hydraulic fluid

[ghostmonkey]

Hey all,right got a tiny leak from my front brake m/c where the pipe goes into it from the res pot.....pretty sure its not the rubber seal,but the actual pipe not fitting 100%. The res is one of izax's a and they did say that the pipe going into the m/c was a bitch to get right
So what I'm looking for is some kind of sealant/bond that's OK to use with brake fluid just to seal better
Any recommendations much appreciated

[locomotion]

Are you talking about the supply pipe to the m/c from the res in which case this is not under pressure and only gravity fed. I would smear a bit of red rubber grease round the inlet of the m/c then a good quality clip should hold it nicely

[ghostmonkey]

Yeah that's the one I'm on about,red rubber grease....why didn't I think of that DOH!
I can't clamp it cos I've got billet RES's and the connecting pipe is billet as well
Found bondloc b542 which may do the job,also someone said that wurth orange flange sealent is spos to be good for this
I'll try to get a pic sorted out

[ghostmonkey]

db.tt/jGNZwMAd

Link to pic