|
Post by B2BC on Aug 3, 2014 12:47:25 GMT
|
|
|
Post by B2BC on Aug 3, 2014 12:48:25 GMT
|
|
|
Post by B2BC on Aug 3, 2014 12:49:16 GMT
|
|
|
Post by bigkenx on Aug 3, 2014 17:04:54 GMT
Love the look of the bike exhaust exits tidy under the frame good job
|
|
|
Post by B2BC on Aug 3, 2014 19:27:28 GMT
Love the look of the bike exhaust exits tidy under the frame good job i like it underneath but not sure if it would be better bolted to foothanger with a link pipe im in 2 minds about it at the moment wheres best to position it, not many kats with a underslung exhaust so something abit different but on the other hand the exhaust is great looking and cost near £200 just for the can so abit of a shame to have it tucked out the way i think.
|
|
|
Post by gsx on Aug 4, 2014 0:51:30 GMT
Would run better with it under hanger , give the engine some back pressure
|
|
|
Post by bigkenx on Aug 4, 2014 4:55:30 GMT
id be worried about back pressure if I was drag racing or racing to the shop get a beer , I like the exhaust there looks good but what I like is different to what someone else likes.
|
|
|
Post by B2BC on Aug 4, 2014 9:10:30 GMT
the end can is baffled and the headers ive made my own baffle so that should be enough be using the can and headers on the b12 motor for over 6 months and no problems as of yet. but it could be a concern but ill see how it goes.
|
|
|
Post by B2BC on Aug 4, 2014 13:52:08 GMT
thought it would be better to fit my spare 4into race headers instead of using standard headers glad i did have more clearance on sump and lots of room around headers for oil lines frame clearance ect
|
|
|
Post by B2BC on Aug 4, 2014 13:54:42 GMT
pic of carbs and airfilters fitted dont like how they dont sit right on side panel not sure if there is anything i can do about this would look better if air filters were lower
|
|
|
Post by B2BC on Aug 4, 2014 13:56:22 GMT
new number plate and bracket arrived today
|
|
|
Post by B2BC on Aug 4, 2014 13:58:00 GMT
not sure to go with flush mount indicators fitted on tail piece or fit stick indicators next to plate
|
|
|
Post by B2BC on Aug 4, 2014 13:59:39 GMT
pic from underneath, need to make somesort of undertray but as im not putting electrics underseat not sure if to make a metal undertray or just fit some rubber mats underneth
|
|
|
Post by B2BC on Aug 5, 2014 10:24:10 GMT
received my new kat front fairing today i must say the company i used LPM coventry are very very good all my panels are from them and are very good copys and stronger than originals not that badly priced either defo recommend using them.
|
|
|
Post by gsx on Aug 5, 2014 17:00:40 GMT
Got one on mine and it distorted when the paint was baked , could have cried , hairdryer got it hot enough to reshape
|
|